stokerwhore
02-19-2008, 09:24 PM
marine endurance motor,1000 hp
brand new never assembled
most machine work has been done.
Tall deck brodix block, extra thick steel sleeves(gen4) , big lifter bore(.937)
block is bored to 4.56( for 621cu. on the first set of rings/bore) set for 10.2:1 compresion.
the pistons (flat tops)were custom made by CP.
Oliver billet steel rods 6.635"
Lunati Billet Pro crank 4.75" polished and ready to go
balancing was done by Balance Research
machining was done at Shaver racing.
Calico bearings
Brodix(sunny's) -4 extra cnc heads
Felpro MLS head gaskets #1077
Brodix(sunny's) SA2020 single plane intake, gasket matched. might need to be cut down to sit on the heads right as motor has not been mocked up that far.
Barry Grant stage 4 dominator carb 1290 cfm
Donovan gear drive timing set w/billet cnc adjustment access cover
Bullet Racing solid roller cam .700" lift
T&D shaft mounted rocker arms 1.7ratio
Crower lifters 66291X937H-16 ,severe duty rollers BBC cutaway .937 od w/ hi presure pin oiling
Trick Mmarine two piece polished valve covers with breathers(kit)
Steph's offshore race pan 12 qt.
Hay's billet steel fly wheel
Ati super damper
$21,000
it was cammed with the thought of running all day at 6500 rpm @ +/-1000hp in front of an outdrive. low idle,torque everywhere. probably 200 lbs lighter than a blower motor making the same power.
if you have any Q's i'll try to answer as best i can. thanks for looking -Jas
brand new never assembled
most machine work has been done.
Tall deck brodix block, extra thick steel sleeves(gen4) , big lifter bore(.937)
block is bored to 4.56( for 621cu. on the first set of rings/bore) set for 10.2:1 compresion.
the pistons (flat tops)were custom made by CP.
Oliver billet steel rods 6.635"
Lunati Billet Pro crank 4.75" polished and ready to go
balancing was done by Balance Research
machining was done at Shaver racing.
Calico bearings
Brodix(sunny's) -4 extra cnc heads
Felpro MLS head gaskets #1077
Brodix(sunny's) SA2020 single plane intake, gasket matched. might need to be cut down to sit on the heads right as motor has not been mocked up that far.
Barry Grant stage 4 dominator carb 1290 cfm
Donovan gear drive timing set w/billet cnc adjustment access cover
Bullet Racing solid roller cam .700" lift
T&D shaft mounted rocker arms 1.7ratio
Crower lifters 66291X937H-16 ,severe duty rollers BBC cutaway .937 od w/ hi presure pin oiling
Trick Mmarine two piece polished valve covers with breathers(kit)
Steph's offshore race pan 12 qt.
Hay's billet steel fly wheel
Ati super damper
$21,000
it was cammed with the thought of running all day at 6500 rpm @ +/-1000hp in front of an outdrive. low idle,torque everywhere. probably 200 lbs lighter than a blower motor making the same power.
if you have any Q's i'll try to answer as best i can. thanks for looking -Jas