Toolman
Well-Known Member
- Joined
- Aug 19, 2014
- Messages
- 416
- Reaction score
- 554
Op #6
Hog out and finish bearing bore.
Drill and tap oil fill and oil level check holes.
Drill and tap bearing cap holes.
Edge break.
We're 75% thru the job. All that's missing is the pipe thread water holes. I don't have any more room in the tool changer, so I will do these on a later Op. Next we'll be kicking everything up 10* and hopefully I won't screw it up!
Hog out and finish bearing bore.
Drill and tap oil fill and oil level check holes.
Drill and tap bearing cap holes.
Edge break.
We're 75% thru the job. All that's missing is the pipe thread water holes. I don't have any more room in the tool changer, so I will do these on a later Op. Next we'll be kicking everything up 10* and hopefully I won't screw it up!