Toolman
Well-Known Member
- Joined
- Aug 19, 2014
- Messages
- 416
- Reaction score
- 554
Her she is all put together. 220volt, 3 ph, 3,000 p.s.i. pump. Dual controls (so the dumbass running it has to have both hands on levers, otherwise it could run on one valve). 3 x 3 x .188 wall H.R.T. frame. 1.5 thick alum top plate. Wood shelf so they can store crap. Leveling pads (seen on shelf). 1018, black oxided mandrels. 4" dia cylinder with a 14" stroke.
It shoves both sleeves at once, all in one push. When tube mandrels bottom out on both ends, It's done. Then it rapids out which is controlled by a speed control (the little valve with dial by the levers). 15 sec cycle time. Took about 40 hrs. to design and build.
It shoves both sleeves at once, all in one push. When tube mandrels bottom out on both ends, It's done. Then it rapids out which is controlled by a speed control (the little valve with dial by the levers). 15 sec cycle time. Took about 40 hrs. to design and build.
