RiverDave
In it to win it
- Joined
- Sep 13, 2007
- Messages
- 123,409
- Reaction score
- 151,544
A bearing failed in this causing the pulley to rub against the housing.
When all that happened it pushed some material around so we take the pulley and make the recess concentric with the pulley and then added a chamfer.. Total project took about ten minutes.
But now this should be ready to go hit the water again.
When all that happened it pushed some material around so we take the pulley and make the recess concentric with the pulley and then added a chamfer.. Total project took about ten minutes.
But now this should be ready to go hit the water again.