This is what I started with a berkeley 12-JC-A
I first measured the hydraulic and cable lines in anticipation that they would be long enough to reach the extended position of the diverter after the new bowl and drop snoot were installed.
Next I pulled the transom housing off exposing the bowl and suction housing. I would recommend if you plan on pulling the transom housing off regularly donâ€™t use 3M 5200 like I did itâ€™s great stuff but a pain to get off the transom.
I found an easy was to remove the suction housing from the intake after removing the bolts is to place a jack under the bowl and slowly jack the bowl up to break it loose.
Bowl with Pump Suction Housing
Impeller and Shaft
Intake with stock loader