BiggusJimbus
Member
- Joined
- Dec 23, 2007
- Messages
- 13
- Reaction score
- 5
Hi All,
It's been a long time since I've been around. I need some advice...
I just bought a 1990 Ultra. I knew it needed pump work. It is tired. The shaft was worn at the tail bearings so bad there was about 1/8" of movement. So, I'm tearing it down, but I've hit a snag. Maybe somebody out there has a genius solution. I've used up my genius.
The suction piece appears to have been glued down with some kind of RTV product. It's a 12JG pump, so there is a lot of surface area where the suction piece mates to the intake.
Has anybody fought this battle before?
Any help is appreciated.
Thanks,
Jim.
It's been a long time since I've been around. I need some advice...
I just bought a 1990 Ultra. I knew it needed pump work. It is tired. The shaft was worn at the tail bearings so bad there was about 1/8" of movement. So, I'm tearing it down, but I've hit a snag. Maybe somebody out there has a genius solution. I've used up my genius.
The suction piece appears to have been glued down with some kind of RTV product. It's a 12JG pump, so there is a lot of surface area where the suction piece mates to the intake.
Has anybody fought this battle before?
Any help is appreciated.
Thanks,
Jim.