Recent content by mjc

I read that going to throw her under the bus. I wonder what she thinks about it unless they figure she can get off easier.

That is how they did the Rivera ramps.

Sounds like shine is a good one to try.

There was a flat spot then more ramp and a drop off near the waters edge.

Ramps are concrete just the road around is asphalt. New ramp looks good may get rid of some drama without the flat spot in it.

They were paving the last part yesterday when I drove by.

nope drive them off the road still glued on and leave them there until they get really hungry or figure out how to get off the car.

The last time I had a Bravo done it was cheaper to just replace the lower than rebuild. Don't know if that is true with outboards are not. https://www.wholesalemarine.com/mercury-outboard-replacement-lower-units/ these SEI units are pretty cheap.

where are you located? I have a lift in havasu you could possibly use.

So are they now open everyday? And is breakfast served yet?

I have multiple products hoping to find one line is good for almost everything

To start I usually do my own washing and detailing but am looking for better stuff. I have some of many different companies stuff at this time. I want to get one line of products that works good and get rid of my mismatched stuff some of witch is getting old. So the Question is who make good stuff ?

What you use if you are stupid and ran out of ammo.

So how much are beers?

yes that was Caliber 1 boats and that is Cliff's wife. He owned the company until he got in trouble with the CA tax board for not paying all the taxes on the sold boats. Being as that is a 93 I would check the glass work on the top to bottom seam. My Caliber was a 93 and when they did that work...