Recent content by probablecause

Asians!!!!

Shed now, Grow room in 6 years

If I were to dry wall it, I would put a nail-plate on it.

Ok, ...sections of 334.10(3) and the revised language of 334.10(1), it is clear that nonmetallic-sheathed cable is permitted to be installed exposed in one- and two-family dwellings, their attached and detached garages, and their storage buildings. That is what I am going off of for my detached...

I am not sure what you mean by exposed and that ship has sailed.

About 25' total.

I would not run Romex all the way through it would just go into the pipe for about 6" as stated, it would be the 12 2 wiring only

I have a sub-panel in my RV garage and a tube that goes to a shed next to it. My question is can I run romex from the sub to the tube and then just the 12/2 wire through the tube to the shed? or do I have to put a box on top of the tube and then run the romex to it? Thanks,

Please use a more politically correct term such as "Urban Outdoors-man" Thank you.

I know, quite the Boa Constrictor tube.

Copy.

Just farting around with it. BTW, I did disconnect the negative for about 10 minutes (and Positive) after I removed everthything and it ran fine but then started throwing lean codes on both banks about 10 minutes into the drive. I was thinking about installing a cold air filter kit which would...

Ok, so I pull the air filter out of my 2005 5.4L truck and rip off the long factory snorkel. The only thing left is the air filter body (with MAS) that connects to my throttle body. I fire the truck up and it immediately runs like shit. Pull the MASS and clean it and still runs like shit. Oh...

Absolutely Classic!