Anybody have any experience with this shop out of North Carolina for marine repower? Good, bad, other? Looking at either a long block or turnkey tall deck package.
Just a shot in the dark, but does anyone have a VST diaphragm and O-ring for the cap and body? I really only need those parts and would like to avoid purchasing the entire rebuilt kits. After 19 years the diaphragm called it quits.
Two pair for sale. In great shape. Kids out grew them. These are pricey when new.
Mens size 8
Girls size 4 (purple)
$20 each or both pair for $30.
PM if interested. Located in San Diego.
Parting out a marine SBC. Motor came out of a 2000 Mastercraft ski boat with the injected LTR motor. Bent #7 exhaust valve due to PTV contact.
I am open to offers....
Block is a late model 1 piece rear main seal, 2 bolt mains, no mechanical fuel pump mount. $100 OBO
Vortec heads 906...
Considering building a 427 SBC for a boat based on the DART SHP small block.
What heads would work best? Targeting 9.5:1 +/- .3
I'm leaning towards Dart or AFR but am have not nailed down runner size.
Any thoughts or suggestions?
Any recommendations or experience with aftermarket exhaust options for stroker SBC? Currently using GLMs with 4" thru hull. I'm just not sure I can justify the cost of some of these systems IF I don't see a substantial performance increase. I'd need to see 300-500 rpm for me to consider...
I've got the itch for another engine project. Not sure which way I want to go. I'm eyeballing a 427 Dart SHP option or a 540 inch class big block route. It would be hitched to a Bravo 1 drive in a 21' class boat.
I like the uniqueness and sleeper aspect of the Dart 427 SHP, plus I have all...
Came out of a 1995 Merc 350 Mag EFI/MP. All were cleaned and flow tested. Will include test sheet. I ran them briefly in the motor after cleaning (about 10 minutes of total run time).
Injector : KEIHIN 5JAB KN-1
I don't need them any more. Want them gone. From Merc these would cost...
Does anyone have any experience using this short block in a marine application? Seems like it would be a nice sleeper motor assuming all the associated marine mods were done to it.
On a related note, how do you install a double roller timing chain set under the Merc short leg water pumps...
Looking for some collective thoughts on the Bravo 1 raw water pump. I have two actual pumps on hand. One installed in the boat and another as a spare. Its a full up round spare, new impeller, seals etc. Pull the old and install the new kind of deal.
I usually swap out the pumps when it...
Had a small ding on the Bravo 1 from a submerged impact years ago. Minor chip off the front leading edge corner and bent the skeg to starboard a little. No big deal or performance decrease that I could detect but it was bugging me.
Finally bit the bullet and took it to get repaired. Called...
Got new tires on my car. The old front have some tread left. Tossing them up here for those who might be interested. Goodyear F1 275/40 R17 off a Z06.
$75 for both tires.
Prefer local pickup but will drive a short distance to meet someone. I'll ship if buyer pays shipping.