Search results

A little hard to see but In the first photo, guardian was set because of the sea pump pressure. If I'm seeing it correctly, the engine is just under 4K RPM and the sea pump pressure is under 5 psi. That is why it went into guardian mode

Its for the indicator

Wanna bet? I have one for every size! LOL. Damn boat shops!

It changes the input shaft location however you can just space the drive plate out to accommodate. Cool project!

Get a BIG slide hammer!!!! That is the best advise I can give...

20 Feet in length Mercury Racing 300xs Outboard Stainless Steel Cable Steering Custom Steering Post Beard Seats ATL Race Fuel Bladder Tandem Axel trailer Custom Gages Custom Shifter Ballast Tank Dual Trim Controls Runs 90+MP Tested and Proven Asking Price: $50,000.00 Boat is located in...

I thought you knew everything???:headscratch:

Ive been called worse... Thanks for the plug Cambelly

Some... Yes

I would check the main power fuse on the starter. Its that white/red/or black (depending on the amperage) fuse that hangs off the starter main post. If it goes bad you will have nothing. If that checks out I would check the key switch at the main power and "keyed" ignition wires (the red and...

We were headed home from the lake test... Mike @ Prime

21

21

Flatty

24'

Yeah that's a UFP actuator....

If its a UFP actuator you have to remove it to replace it. Can be a pain in the ass if you don't know what you're doing. We did 3 this week already must be something in the air this week. Let me know if we can help. We are in Rancho. Thanks, Mike @ Prime 909 484-8338

Here is on we just finished...

You're right its a P.I.T.A!!! When you tear the leather, it's game over. Then you start all over again. Like you said all done by hand with a needle like a fish hook. Not to mention that all the pre-punched hole better be straight or it looks like a drunk 3rd grader did it when you finish...