I know these came off of a 440 V8. Other than that, can you tell what model head or anything? 906's? Are they worth anything? They only have about 500 miles on them since rebuilt and then the motor was pulled for a hemi swap.
Chgo shot a guy who pointed a gun at them this weekend so of course some quiet protesting was required.
https://www.chicagotribune.com/news/breaking/ct-chicago-downtown-looting-20200810-3zwa3b7zzrc5vdyb4qjqywrjvu-story.html
2002 Laveycraft Nuera 29
500 EFI with 15hrs on full rebuild from Octane Marine Phx (heads redone, new valves, springs etc., new rings/bearings, new transom gasket, new coupler, new impeller, new plugs/cap/rotor/wires/filters, drive gimble rebuilt) hull has 412hrs
IMCO SCX Extreme upper/lower...
I have a reservation for weekdays in June at Nautical resort. If you solo launch, is there a spot near the ramp to beach the boat or something to put the truck/trailer away? I solo launch all the time so not worried about that part, but usually I'm at a spot with a pier to tie up to. Thanks!
What transducer ware you guys running that actually works shooting thru the hull? Have a Lavey 29 nuera and the airmar-78 wont get a reading thru the hull. Or if you don't know what transducer you have, what brand depth sounder are you using that actually works installed this way? Thank you
Maybe I missed the thread, but kinda surprised no one is talking about the Havasu mayor saying tourists stay away. At least he admitted they can not close a Federal waterway, but I am sure the City could order launch ramps closed...
All of these BVI trips got me researching it and I'm about 80% we are going to rent a power cat for 7 days via Marinemax. One items i don't see in anyones posts, did you get the damage insurance at like $90 a day or did you do the Credit card hold for damage? I have State Farm on my boat, does...
Anyone have better experience between 3M marine compound and finishing material vs meguiars marine restoration system? Looking to polish up the boat while it’s still cool enough out. Mostly white with some darker graphics, some oxidation on the sides but nothing horrible.
I’ve been checking...
Where is the go to shop for a top end rebuild in Havasu or Phx? 500 efi and I want to redo the heads with new valves, springs everything to make them like new again. Looking for a shop that can do the tear down etc. not just the machine work for the heads. Thanks!
I have a 29' Lavey with a 500efi and IMCO SCX extreme outdrive. Current prop is a Bravo I 26P but the motor will only pull it to 4800rpm's. I had the prop checked and its in spec at 26P with no damage or changes. The motor was checked out as well and has no issues other than the gas is from...
So I have 3 Bravo I props. 22p, 24p and 26p. All stock from what I know. I have a scx outdrive with the big shaft so I rub their solid insert.
The insert slides right into the 26p and out by hand. I went to insert it into the 22p and 24p but it stops short (see pics). I don’t want to force it...
I need to replace the factory temperature sensor which goes to the dash gauge with the proper gaffrig sender. Gaffrig offers them in several sizes, anyone know if the 500 efi takes a 1/2”, 1/4” etc?
After a lot of looking, I found the right boat and its in the driveway. 2002 Lavey 29 with a 500 EFI. Already had it checked out, compression test etc. so I know everything is good. Plus it has a monster SCX extreme outdrive which is always a plus. I'll be on Lake Pleasant this weekend...