In the process of building a gazebo/barbecue island.
We are putting in a typical 36 inch gas barbecue.
We also would like to put in a 36” ish griddle.
Has anybody installed a griddle in a barbecue island in the backyard?
Table top style?
Built-in style?
Cart Style?
Any...
Does anyone have the link to a video of the place in quartzite that has just about every old car, planes, buses.... the place is Desert Gardens
The video is fairly long and The OWNER is with camera crew being interviewed.
Search here couldn’t find it.
Brian
Spent the last few weeks finishing up this project that had been sitting for a couple years.
8’ long (96”)
62 pounds wet
Twin Turbine 170000rpm
Shaft 30000rpm
Speed 85
Runtime 15min
Took the boat to Riverland on the Strip last Monday for its maiden voyage.
Boat fired up and ran flawless. Ran...
Last year Rovey’s Needle was on the list, never made it, list was to long.
Going out this Saturday for a ride to Rovey’s Needle and a couple other spots.
Ride is fairly short, so it not an all day deal.
Leaving Saturday AM
If interested meet at South Human Bean or cement plant??
Brian
Wife and I decided to RZR to Topock today and scout a bit more of our Oatman trip.
Left Havasu taking our normal route north toward the dump and decided we would go west side this time. So near the dump we headed west crossed the 95 and then headed north and hugged the refuge boundary then...
What a weekend on the rzr. Friday we headed out from Parker to Lake Alamo with 33 others cars. Almost all the drivers had dirt racing experience or are still active including racing this weekend in the Parker 425.
One way to Lake Alamo is 75 miles. We took one route there and different route...
1. Need electrical run in the garage. Wall Surface conduit, for outlets and to connect CnC mill and lathe. Subpanel already in garage.
2. Run galv pipe for air lines in same garage
Thanks
Brian
Looking for ideas on coating the garage floor.
I like the type of coating that is in Home Depot's, not sure if it is durable for my application???
I need a fairly smooth surface since I have a CNC Mill and Lathe, easier to pick up chips Etc.
I also will be moving the Boat and RZR in out...
Looking for a machine mover that can move from Huntington Beach to Havasu.
Any Recommendations appreciated
CNC - Knee Mill
Lathe
Air Compressor
Bead Blaster
Tables (3)
Cabinets (3)
Rack (1)
Misc Stuff
Brian