ACS
Well-Known Member
- Joined
- Dec 10, 2010
- Messages
- 215
- Reaction score
- 216
Looking to sell my mustang. I bought this car in 95 when I graduated high school. I drove it for two years while I accumulated the parts.
Sometime between 98 and 99 the project began. I installed everything I could do myself but then it was time for some fabrication. I dropped the car off at the fabricators where it sat for 3 years with virtually nothing done. By this time I was over it so I picked it up and put it in my garage. The car has been there covered until I recently moved. I no longer have space in my garage for it so it is time to go. I’m not going to let it sit in my driveway and rot away.
Parts are as follows:
351 Cleveland bored and stroked to 392” (built by Pete Fleming)
Twin turbos Turbonetics 60-1
forged crank and pistons
H beam rods
4 barrel Cleveland heads with epoxied And raised intake ports and inconel valves
5 speed Tremec TKO transmission
Mcleod dual disc clutch
Currie 9” differential with 3.55 gears and 31 spline axles
Koni 5 way adjustable shocks
Wilwood 12” rotors with 4 piston calipers
Griggs tubular K member
Flaming rivers rack and pinion
There are a lot more parts but these are the main items.
I’m not sure how much I’m looking to get but I am open to reasonable offers.
Located in Simi Valley
Thanks for looking,
Nicholas 805 27nine-072nine
Sometime between 98 and 99 the project began. I installed everything I could do myself but then it was time for some fabrication. I dropped the car off at the fabricators where it sat for 3 years with virtually nothing done. By this time I was over it so I picked it up and put it in my garage. The car has been there covered until I recently moved. I no longer have space in my garage for it so it is time to go. I’m not going to let it sit in my driveway and rot away.
Parts are as follows:
351 Cleveland bored and stroked to 392” (built by Pete Fleming)
Twin turbos Turbonetics 60-1
forged crank and pistons
H beam rods
4 barrel Cleveland heads with epoxied And raised intake ports and inconel valves
5 speed Tremec TKO transmission
Mcleod dual disc clutch
Currie 9” differential with 3.55 gears and 31 spline axles
Koni 5 way adjustable shocks
Wilwood 12” rotors with 4 piston calipers
Griggs tubular K member
Flaming rivers rack and pinion
There are a lot more parts but these are the main items.
I’m not sure how much I’m looking to get but I am open to reasonable offers.
Located in Simi Valley
Thanks for looking,
Nicholas 805 27nine-072nine
Last edited: