Sheave pully, where to buy?

[Your ad here]

I goofed up this sheave while removing it from a 24HP Honda engine. Setup for v belts. 5 groove, 4 same, plus 1. Square key and I think 1" pto shaft. Where are some places that have this stuff? The manufacturer of the equipment is no longer in business (Target Concrete Equipment).

 

[Your ad here]

Can someone edit the title to say pulley instead of pully?

 

[buck35]

Should be a part# on it that can be cross referenced. Take it to a belt shop and they can measure it and find what will work for you .

 

[TITTIES AND BEER]

Mc master-Carr should have it

 

[Skinny Tire AH]

Long shot but try Merit. They also run multi-v stuff. If not, you’ll need to go to Motion Industries, Kaman Bearing, Purvis Industries or maybe even gasp...Graingers.

 

[Flying_Lavey]

Any drive/bearing/motor shop should be able to easily figure out what it is and options you have.

Sent from my LM-G710VM using Tapatalk

 

[TrollerDave]

AAA electric motors, one in L.A., Riverside, and Anaheim.

Sunset Industries in Cerritos.

 

[monkeyswrench]

As stated, Kaman bearing, or King bearing. Shouldn't be too hard to find. If so, you have an excuse to buy a lathe

 

[Chili Palmer]

Mc master-Carr should have it

McMaster-Carr has everything you never knew you needed.

 

[Your ad here]

McMaster-Carr has everything you never knew you needed.

Mcfaddendale Hardware does too. Sometimes I'll pack a lunch when I go to Mcfaddendale.

 

[Carlson-jet]

These are basically lawn mower parts so to say. I looked at sterns and found a few that were close but the dimensions given do no give the whole picture. That said, In the time this thread has run, that part could have been welded and repaired.

 

[Your ad here]

Stopped in at Grabber Power products in Tempe and got a Husqvarna part number. Hopefully its the correct one. I can find 4 groove pulleys but this one I need is a little different. Its a 5 groove, 2.65" OD, 1-1/8" bore, 1/4" key, and 2 set screws. 4 grooves are for 3vx belts and 1 is for an A belt. That combo is what I am unable to find or figure out what its called.

 

[Buggydave]

You are in Arizona? Try APD Power Equipment, near Kyrene and Guadalupe.

 

[Carlson-jet]

Stopped in at Grabber Power products in Tempe and got a Husqvarna part number. Hopefully its the correct one. I can find 4 groove pulleys but this one I need is a little different. Its a 5 groove, 2.65" OD, 1-1/8" bore, 1/4" key, and 2 set screws. 4 grooves are for 3vx belts and 1 is for an A belt. That combo is what I am unable to find or figure out what its called.

That is quite the henstooth you have there. I've spent more time looking for you then it would have taken to repair..LOL
What was the Husqvarna number?
What is this off of. Concrete cutter?
What is the model# of the piece of equipment?