Groper
Well-Known Member
- Joined
- May 6, 2009
- Messages
- 2,218
- Reaction score
- 1,867
Pulled the motor and started on the bilge, this stuff was flaking in a few spots so pulled up on and it came right up it's thick stuff the grey underneath I'll assume is Gel-Coat and trany fluid and or gas got underneath it and started the bubbling.
It looks like it was added after all the rigging was completed as you can see where it comes up the sides of the large strut washers.
Q: clean it up and leave the grey underneath or scrape it all up remove all the nuts & washer from the hardware and roll on bilge epoxy paint ?
Disclaimer: I know I should have put this in the Fiberglass/Gelcoat section but it's crickets over there.
It looks like it was added after all the rigging was completed as you can see where it comes up the sides of the large strut washers.
Q: clean it up and leave the grey underneath or scrape it all up remove all the nuts & washer from the hardware and roll on bilge epoxy paint ?
Disclaimer: I know I should have put this in the Fiberglass/Gelcoat section but it's crickets over there.
Last edited: