LC925
Well-Known Member
- Joined
- Oct 5, 2017
- Messages
- 684
- Reaction score
- 1,033
So I noticed that my drive (upper) seems to be “grinding” against the transom plate/gimbal when you trim up/down on the Starboard side. I will be taking it into a shop to get some advise on if maybe a shim kit is needed?!? What say the RDP’rs on what I can show here. 600SCI/XR roughly 30 hours on complete set up. Attached both inside and outside views as well as straight down look where you can see there is a large gap on the Port side compared to the Starboard side that’s rubbing. Nothing seems loose. Misaligned?!
Also, safe to assume an exhaust baffle “fell off” because I doubt it’s only used on one side?
Also, safe to assume an exhaust baffle “fell off” because I doubt it’s only used on one side?