AGM batt rack

[AZLineman]

Throwing this out there before I put it up on FBM (not to be confused with FJB) I'm buying parts like crazy right now so I need to sell some shit that I'm never gonna use. This AGM battery rack was made by skater for a 36 quite a few years ago and was shortly used in a 28 Daytona. It is a solid piece of 1 inch billet bottom and the entire thing has been hard anodized. Dimensions are 37" x 11" x 7-1/4" tall. I vaguely remember the this piece costing over 2K to fab at the time. It's very nice and my prices set at $400. Transportation details can be discussed. If it doesn't sell I'm going to cut it in half fab two more end plates and have a pair of dual battery holders.

 

[AZLineman]

Last time before I cut it in half

 

[Motoxxxloak]

I run odyssey pc2150 batteries. They are 13.06Lx 6.89Wx 9.59H. do you know if these fit in the slots? If so I’ll take it.

 

[Motoxxxloak]

or if you can get me the measurements of the slots, I can see if they make a battery that fits as I considered replacing them this season anyways

 

[AZLineman]

I will get you the measurements

 

[AZLineman]

Batt slot/recess-
6-5/8" W and it looks like the batteries that were in it were 6 1/2 W

31-1/4 L so 7.75" ish x 4. Looks like the batteries were 7.5" ish

6-3/4" tall max (could easily be spaced up a little and the recess will accept as low as 6")